norris electric

Why Power-Save 1200?

The Power-Save 1200 is a small grey box that fits neatly to your breaker panel. The unit was designed with the homeowner in mind, lowering electricity usage, lowering electric bills, increasing motor and appliance life and providing surge suppression for the equipment inside your home. Residential customers throughout North America could see a typical savings of 10-25% on their power bills, but money isn't all you are saving when you purchase this energy-wise decision. It has many positive environmental implications:

• Reduces the amount of inductive load in commercial & residential environments.
• Reduces electricity required by inductive loads (motors)!
• Enhances capacity of existing electrical system & eliminates harmful power surges!
• Protects appliances and sensitive electric equipment!
• Reduces harmful effects caused by electrical noise!
• Power Factor Optimization!

The Power-Save 1200 is very easy to install. The unit is simply wired into a dedicated two-pole 20 amp circuit breaker. The unit can be installed outdoors or indoors, at the main breaker panel or at a sub-panel at your home.

Save up to 25% on your commercial / Industrial Electric Bills!

The Power-Save 3400 & Power-Save 3200 Reduce the Amount of Inductive Load in Commercial and Industrial Environments

 

 

 

 

 

The Many Benefits of the Power-Save 3400 & Power-Save 3200 Include

Why Power-Save Energy Kit?

Power-Save Energy Saving Kits are cost-effective way to purchase a combination of Power-Save products! A Power-Save Energy Saving Kit significantly reduces electric bill by eliminating wasted electrical consumption and increasing the overall efficiency of the home. In the event you decide to 'go solar' down the road, the Power-Save Energy Saver Kit will allow you to install a much smaller and less expensive solar system!

Power-Save Energy Saving Kits include: The Power-Save 1200 Energy Saver, The Power-Save Solar Attic Fan, Power-Save Radiant Barrier, and Power-Save Duct Seal System. Power-Save Attic Fans: Saving energy in your home must start at the top. As warm air rises, it collects in the attic making your entire house hotter and your air conditioning less efficient. The Power-Save Solar Attic fan removes hot air from the attic keeping your home cooler while maximizing your air conditioner's efficiency. The solar powered fan draws no electricity from the utility and will cost you nothing to operate!

Power-Save Radiant Barriers: Radiant Barriers are installed in homes-most commonly in attics-to reduce summer heat gain and winter heat loss, which helps lower heating and cooling costs. The barriers consist of a highly reflective material that reflects radiant heat rather than absorbing it.

Power-Save Duct Seal: Leaky ducts can reduce heating and cooling system efficiency by as much as 20 percent. Sealing and insulation ducts increases efficiency, lowers your energy bills, and can often pay for itself in energy savings.

Why Power-Save Solar?

Solar electricity is no longer the energy of the future; it's the energy of today! By making solar truly affordable and accessible, Power-Save has made it possible for everyone to reduce or eliminate electric bills while improving the quality of our environment. Power-Save's complete consumer ready solar systems are designed to simplify the process for the end-user and provide the most cost-effective solar solutions on the market. In many states, government incentives and rebates may off-set your purchase price entirely!

Power-Save Grid-Tied Solar Systems: Power-Save Solar grid-tied systems do not use batteries! The panels work by producing DC power during sunlight hours and converting it to AC power through an inverter. The inverter then feeds the load required by the home, before pushing the remaining AC power through a "net meter" out to the grid.

Net meters are provided by your utility company when you install the system. The net meter is a bi-directional electric meter that spins forward as usual when you are using more power in your home than you are producing with your panels (at night, for instance), and spins BACKWARD when you are producing more electricity than you are using in your home. This is how you generate credits with your utility!